User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7.6 Sound control
Sound control can only be activated when the unit is operating in stand alone mode or as
master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX. In this operating mode, the device responds to acoustic pulses which are
recorded by the integrated microphone.
1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Soud’ .
2. Conrm the selection with [Setup].
3. Use [Up] | [Down] to select a mode between ‘SO.01’ … ‘SO.12’ .
4. Conrm the selection with [Setup].
5. Use [Up] | [Down] to adjust the microphone sensitivity in a range from ‘SU.00’ … ‘SU.31’ .
Operating
40
LED Pot QCL RGB WW 15°, LED Pot QCL RGB WW 40°
LED PAR