User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7.2 Programme mode
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Pro’ .
2. Conrm the selection with [Setup].
3. Use [Up] | [Down] to select one of the programmes ‘Pr.01’ … ‘Pr.14’ .
If you have selected programme 01, you can adjust the following settings:
1. After selecting the programme, press again [Setup] and use [Up] | [Down] to select one of
39 static colours.
2. Press again [Setup] and adjust the frequency of the strobe eect with [Up] | [Down] in a
range from ‘FS.00’ … ‘FS.99’ (slow … fast).
Settings for programme 01
Operating
LED Pot QCL RGB WW 15°, LED Pot QCL RGB WW 40°
29
LED PAR