User Manual

© The Fulton Companies 2013
OPERATION PHW-IOM-2013-0214 SECTION 3
3-16
! WARNING
Do not operate, or allow others
to operate, service or repair this
equipment unless you (they) fully
understand all applicable sections
of this manual and are quali ed to
operate/maintain the equipment.
Non-Fulton product information is for
reference purposes only. No Fulton
document may substitute for full
review of documentation available
from the component manufacturer.
you can look at your curve in the previous screen, press Show Line. See
Figure 39.
FIGURE 39 - SELECTING CENTRAL HEAT SETPOINT
5. Master Boiler – While still in the Advanced Settings Screen arrow over to
Warm Weather Shutdown. If required, Select Enable and press Shutdown
after demand ends. Then select the Setpoint (outside air temperature) at
which you want the system to shut down. See Figure 40.
FIGURE 40 - WARM WEATHER SHUTDOWN
6. For the Master Boiler, back out to the Con guration Menu, select Lead Lag
Slave Con guration and select Slave Enable - Enable slave for built-in Lead
Lag Master. See Figure 41.
FIGURE 41 - LEAD LAG SLAVE CONFIGURATION