User Manual

© The Fulton Companies 2013
INSTALLATION PHW-IOM-2013-0214 SECTION 2
2-22
90° ELBOW
WIRES AND INSULATION
TO COMBUSTABLES,
AIR SPACE CLEARANCES
MAINTAIN MIN 9" / 22.86 CM
EXHAUST PIPE
& FITTINGS
AL294C
AIR INLET
RISE TO RUN: 1/4" PER FOOT
Pulse
Boiler
( SIDE VIEW )
1/4" TAPPING FOR WATER\
100 PSI MAXIMUM
INSTALL SUPPORT STRAPS AND SPRING HANGERS
AT 5FT / 152CM HORIZONTAL
INTERVALS AND AT ELBOWS
( SPRING HANGERS ARE REQUIRED )
SUPPORT
ROOF
RECIRCULATION DURING DIFFERENT
POSSIBLE TO PREVENT FLUE GAS
SHOULD BE SEPERATED AS FAR AS
AIR INTAKE AND EXHAUST TERMINATION
NOTE:
( } 3 IN. / 7.62 CM )
4FT / 122 CM
FLASHING
ADJUSTABLE
SPACE CLEARANCE
IN REQUIRED AIR
INSULATION
DO NOT PLACE
PVC PIPE
FIRE STOP
METAL PLATE
PIPING
ABOVE AIR INTAKE
MIN 4FT / 122 CM
ADJUSTABLE
FLASHING
ADHESIVE SEAL
STORM COLLAR
OF AIR INTAKE OPENING
EXHAUST STACK IS DOWNWIND
SCREENED INLET
IF SNOW ACCUMULATION IS
APPLICABLE, OPENING TO BE
1 FT. / 30 CM ( MIN. ) ABOVE THIS
NORMALLY EXPECTED LEVEL.
( SUGGESTED TERMINATION CONFIGURATIONS )
TYPICAL ROOF PENETRATIONS
WIND CONDITIONS.
NOTE: STACK SHOWN IS FOR REFERENCE PURPOSES ONLY. OTHER CONFIGURATIONS MAY BE ACCEPTABLE.
EXHAUST
USE OF ISOLATION CUBES OR SPRINGS IS REQUIRED
EXAMPLE OF SPRING HANGER
PROPER TRAP HEIGHT MUST BE ACHEIVED, AS SHOWN IN FIGURE 7
FIGURE 14 - TYPICAL CEILING AND ROOF PENETRATION DETAIL