Data Sheet

Fullpower Labs Proprietary Information
Page 20 of 22
The requirement for KDB 996369 D03:
1. List of applicable FCC rules
FCC Part 15. 247.
No. Description
1 Peak Output Power
2 6dB and 99% Occupied Bandwidth
3
Conducted Band Edges and Spurious
Emission
4 Power spectral density (PSD)
5 Conducted Emission
6 Radiated Band Edges and Spurious Emission
2. Summarize the specific operational use conditions
This device is intended for OEM integrators only. Please see the full grant of equipment document for
restrictions.
3. Limited module procedures
The module is a Limited module, the modular have it’s own RF shielding, minimum signaling amplitude,
buffered modulation/data inputs, and power supply regulation(3.3V±5％) and all these information please
see the Hardware Specification and Electronic Specification.
4. Trace antenna designs
The moduleuses used the PCB antenna, please see above antenna designs information.
5. RF exposure considerations
The host device manufacturer should confirm that a separation distance of 20 cm or more should be
maintained between the antenna of this host device and persons during the host device operation.
6. Antennas
The device itself has no antenna, customer can use the antenna as above trace antenna list type
Or other antenna gain of the final device or host device cannot be greater than 18dBi
7. Label and compliance information
If this certified module is installed inside the host device, then the outside of the host must be labeled with
“ Contains FCC ID: 2AF2O-FPM20 and IC: 20700-FPM20”.
8. Information on test modes and additional testing requirements
The host manufacturer can use the software of SecureCRT Tool to make to make the wifi transmit
continuously.