Installation & Use Manual

12 13
EN
are switched-ON at the same time. If
only the inner heating circuits should be
used, the outer heating circuit can be
switched-OFF by means of the multi-
circuit key or in individual steps.
By operating the multi-circuit key the
respective outer circuit of the assigned
active cooking zone (setting π "0") can
be cutoff anytime. An activated outer
circuit will be indicated by an additional
LED. A renewed operation of the multi-
circuit key will add the outer circuit(s)
at any time, the assigned LED´s glow
again (toggle-function).
If a cooking zone other than the one with
multi-circuit function will be selected,
the multicircuit status will be changed
and all cooking zones will be deselected
(the decimal point extinguishes).
Behaviour of dual-circuit cut-OFF:
If the heating element to be controlled
is a triple-circuit heating element, the
course of action is as follows:
• The first activation of the multi-circuit
key cuts-off the outer heating circuit
and the top LED extinguishes.
• A second activation of the multi-
circuit-key cuts-off the middle
heating circuit. (also the bottom LED
extinguishes.)
• A third activation adds the middle
heating circuit again. A further
activation adds the third heating
circuit as well and the assigned LEDs
glow again.
Audible signal (buzzer)
While the control is in operation the
following activities will be signaled by
means of a buzzer:
• normal key activation with a short
sound signal.
• continous operation of keys over a
longer period of time (_10 seconds)
with a longer, intermittend sound
signal.
Timer function (optional)
The timer function is realized in two
versions:
• Stand-alone timer 1..99 min: sound
signal when the time is over (= minute
minder). This function is only available
when the cooktop is not in operation,
i.e. when there is no cooking.
• Cooking zone timer 1..99 min: sound
signal when the time is over, four
cooking zones can be programmed
independently.
Timer as minute minder (stand-
alone):
• If the control is OFF the standalone-
timer can be operated byactivating
the timer key. Thetimer display shows
"00".
Operation of the Power-key putsthe
control back into the stand-by mode
and the standalone-timer will be cut-
off.
- Time changes can be made with
1-minute increases using the clock
key from 0 to 99 and the MINUS key
from 99 to 0.
- Continuous operation of the clock
key or MINUS produces a dynamic