Installation Manual

EN
7
To connect to the water supply system (for appliances
equipped with ice makers) a 1/4” waterline with accessible
shut-off valve must be supplied.
The appliance is provided with a water adapter elbow
which is suitable for the recommended water pressure and
complies the applicable food and water regulations.
The water filter cartridge, which is provided with
the appliance, should be installed according to the
accompanying instructions. The solenoid connection on the
appliance is 3/4” diameter but is metric threaded (NPT).
A standard garden hose threaded connector such as a
braided stainless hose found at typical hardware stores will
strip or damage the solenoid threads. It is recommended to
use only the supplied 1/4” quick connect elbow adapter
for connecting a 1/4” copper or polyethylene source water
line to the appliance.
IMPORTANT
Do not use extension cords and/or multiple adapters for
the power supply connection.
ELECTRICAL AND WATER SUPPLY BEHIND THE UNIT
Professional Built-In Series Professional Series
E
W
E
W
E
W
E
W
3.3 Energy: Alternatives and Home Automation
If energy is supplied through an alternative energy power
source (solar, geothermal, etc..) or if home automation
systems are installed with carrier signals in the power
lines, it may be necessary to install an isolation transformer
(not supplied) to prevent interference with the appliance’s
electronics.
Professional Built-In Series:
FIG.1 - BACK OF APPLIANCE
Water connection
Electrical connection
Operate as follows:
• Unwind the electric cable and connect it directly to the
wall socket.
• Make sure the appliance is in the Stand-by condition and
that all lights are off; should it be not so press the Unit
button
to switch it off.
FIG.1
1