Installation Manual

EN
22
7. Completing The Installation
7.1 Anti-tipping safety assembly
NOTE
If the appliance(s) is not connected through the side
profile trims to secured cabinetry you must install the anti-
tip brackets to ensure the product does not fall forward
during use and cause damage or injury. Failing to secure
the appliance(s) securely will void any warranty claim
attributable to a tipping situation.
Operate as follows:
The brackets should be applied as illustrated using the
provided screws If using the anti-tip brackets, lag into
wood framing or concrete - drywall will not hold the
weight of appliance.
Place a bracket on the top of the appliance in
correspondence to the fixing holes and against the wall
[ 1 ].
2 x
6 x
152 (6”)
59 (
2
3⁄8
”)
45 (1
5⁄8
”)
1
• Mark up the holes position on the wall [ 2 ].
2
• Drill the wall with an 8 mm (3/8”) bit and insert the
expansion plug [ 3 ].
3
• Reposition the bracket and fix it first to the cabinet and
then to the wall [ 4 ].
4
NOTE
In order to use the anti-tip brackets on the top compressor
models, it will be necessary to temporarily remove the
top, metal ceiling / shield to access the bolting points for
the brackets.