Installation Manual

• At this point, alignment between the panel and adjacent

cabinets can be adjusted using the alignment brackets

and small brackets [ 7] and [ 8 ].

• Vertical alignment: tighten or loosen the screw in the

brackets to raise or lower the panel [ 9 ].

• Depth alignment: working from the inside of the door,

after lifting up the magnetic seal on the handle side and

rotating the plastic covers on the hinge side, adjust the

panel position in the Z-direction by adjusting the shoulder

bolts and setscrews with the 4mm hex key in conjunction

with each other ﬁnally locking each mounting position in

place. [ 10 & 11 ].

NOTE

Once the front panel has been adjusted, check that the

gasket has been repositioned correctly to assure the

door/drawer are closing correctly and avoid operational

errors of the unit.