Installation Manual
EN
11
Drawer Panel
•  When preparing the Drawer Panel, follow the same 
instructions as per the door panel, but make sure 
measurements are taken starting from the top edge [ 7 ].
  The height-adjustment support brackets are oriented the 
opposite way [ 8 ] (note imgs 4 and 8).
7
8
•  Prepare the appliance door (and drawer(s) if applicable) 
for panel mounting by threading the shoulder bolts into 
the recessed receivers and the set screws into the other 
hole  [ 9 ]. Ensure the end with the hex key socket is 
threaded into the door and not on the visible end. Thread 
this in far enough that it is flush with appliance door face 
so as not to interfere with hanging the panel. You will 
adjust these later.
9










