Installation Manual

Professional Built-In SERIES

5.1 Decorative door and Bottom-Drawer panels

layout

The dimensions of the panels are indicated in the table and

drawings on subsequent pages.

Nevertheless, according to the requirements for aligning

with other kitchen structures, the door panel can be higher

than the upper edge of the refrigerator door, and the drawer

panel can be lower than the edge of the drawer.

The panels must be mounted using special brackets which

attach to adjustable devices provided on the door and

drawer and with brackets that anchor and adjust the panel’s

vertical direction.

Brackets and ﬁxing screws are provided with the appliance

and must be applied to the panel as indicated.

Operate as follows:

To prepare the panels to be mounted on the appliance,

follow these steps, working on the back of the panel.

Door Panel

• Draw a vertical center line on the panel from top to

bottom [ 1 ].

• Starting from the bottom edge of the panel, mark the

positioning of the brackets [ 2 ].

• Following the corresponding table, mark the external and

then the internal hole [ 3 ].

• Position the brackets on each set of marks to make sure

they are aligned [ 4 ], if you choose to drill small pilot

holes for the screws pay special attention to not pass

through the panel entirely. [ 5 ].

• Screw the brackets in place [ 6 ].

5. Panels Mounting