Installation Instructions
ManualsBrandsFulgor Milano ManualsCooking Appliances30 Inch Warming Drawer with 2.1 Cu. Ft. Large Capacity, Convection Heating System, Sliding Telescopic Rails, Keep Warm Function, Leavening, Slow Cooking, Thawing, Push Opening, Defrosting, Pre-Heat Dishes, Pre-Heat Coffee Cups, Knob Control, and 2 Halogen
EN
12
Custom drawer front
(Only for Push to Open Drawer)
Custom panels must meet the following requirements:
• Have a minimum thickness of 3/4” (19 mm).
• Have all edges finished.
• If using wood, the back must be sealed to prevent moisture
damage.
• Be capable of withstanding temperatures above 158 °F (70
°C).
Custom Drawer Front Preparation
1. Mark pilot holes on the back side of the panel according to
the dimensions indicated in the following drawing.
2. Drill pilot holes with a 3/32” (2.5 mm) drill bit. Be careful
not to drill all the way through the panel. Pilot holes should
only be 7/16” (11 mm) deep.
A
B C
D D D ==
==
PILOT HOLES
7/16” (11 mm)
dia. 3/32”
(2.5 mm)
Dimensions
inches mm
A 29 - 5/ 8” to 29 - 7/8” 754 to 758
B 10 - 3/ 8” 264
C 7 - 5/ 8” 193
D 8 - 13/16” 224