User Manual

Removing and i nst a lling components
during servicing
Installing and removing memory
expansion
MemorymoduleMainmemoryRemovingmemorySystemexpansionSystem expansion
If you are asked by the Hotline/Service Desk to remove and install the memo ry
expansion yourself, proceed as follows:
Please observe the safety informat ion in chapter "Imp ortant notes", Page 15.
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "
Preparing to remov e components", Pag e 65.
Only use memory expansion modules that have been approved for your
notebook (see "
Technical data", Page 85).
Never use force whe n installing or removing a m emory extension.
Make sure that fore ign objects do not fall into the memory extension compartment.
You must ope n the service compartment to remove or install a memory module. On some de vices,
opening the compartment may expose other components. These c omponents should be removed
and replaced only by authorised specialists. Therefore , b e sure to observe the following :
Individual components can become very hot during operation. Therefore, we
recommend that you wa it one hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of ch apter "
Notes on ins talling and removing boards and components", Page 64.
Removing memo ry modules
3
2
1
1
► Carefully push the two mounting
clips outwards (1).
Memoryexpan
sion
Memorymodul
e

The memory module snaps upwards (2).
► Pull the memory module out of its slot
in the direction of the arrow (3).
Fujitsu 67