Design Technical Manual


FUNCTION SETTING
4) Pressing the SET TEMP.
p
button or SET TEMP.
q
button, select a remote controller
address (select the indoor unit you want to operate).
Ex.) When remote controller address “01” is selected
Remote controller address
5) Press the FAN button so that the “Function number” display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to set up the function number.
Function number
6) Press the FAN button so that the “Setting number” display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to set up the setting number.
Ex.) Function number : 30, Setting number : 01
Setting number
7) Pressing the START/STOP button, conrm the setting.
(The data will be transferred to the indoor unit.)
ERROR
When the data was normally set up on the indoor
unit.
● When the data was not set up on the indoor
unit (-- is displayed.)
● Set up the data again according to the
procedure in step 5), 6) above.
GOOD

FUNCTION DETAILS
Refer to 2-8. FUNCTION DETAILS.
- (07 - 118) -
FUNCTION SETTING FUNCTION SETTING