Design Technical Manual

5) Again, referring to the Settings List shown below, press the SELECT button (SW108), and
display the code number of the function you want to set on the LED104.
Ex.) To select the Emergency Stop function
LED105 LED104 LED105 LED104
Next, press the ENTER button (SW109), and conrm the selection of the function you want to
set.
LED105 LED104
LED105 LED104
A ashing display on the LED104 changes to an illuminated display.
This completes FUNCTION SETTING.
6) To exit FUNCTION SETTING, press the ENTER button (SW109) in the setting completed
status shown in step 5) above.
*2 : 5 seconds after, even if ENTER button(SW109) is not pressed , LED105 changes to a ashing display
automatically.
LED105 LED104
LED105 LED104
*2
Then, press the MODE/EXIT button (SW107) to exit FUNCTION SETTING MODE.
LED105 LED104
LED105 LED104
7) To set another function, press the ENTER button (SW109) in the setting completed status
shown in step 5) above.
LED105 LED104
LED105 LED104
Repeat steps 4) and 5) above to set other functions.
When all settings are complete, perform the operation described in step 6) above to exit.
- (07 - 60) -
FUNCTION SETTING FUNCTION SETTING