Design Technical Manual

z
Refrigerant circuit address setting
9) Pressing the SET TEMP.
p
button or SET TEMP.
q
button, select a remote controller
address (select the indoor unit you want to operate).
Remote controller address
Ex.) When remote controller address “01” is selected
*If the indoor unit you want to operate has already been selected, skip step 9).
10) Press the FAN button so that the “Function number” display ashes. Then, press either
the SET TEMP.
p
button or the SET TEMP.
q
button to display function number “02.”
Function number
11) Press the FAN button so that the “Setting number” display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to set up the refrigerant circuit address
data. (The setting range is from 00 to 99.)
Refrigerant circuit address data
Ex.) When refrigerant circuit address data “18” is set up
12) Pressing the START/STOP button, conrm the selected refrigerant circuit address data.
(The data will be transferred to the indoor unit.)
When refrigerant circuit address data was
normally set up on the indoor unit.
● When refrigerant circuit address data was not
set up on the indoor unit (-- is displayed.)
● Set up refrigerant circuit address data again
according to the procedure in step 11) above.
GOOD
ERROR
- (07 - 42) -
FUNCTION SETTING FUNCTION SETTING