Design Technical Manual
Table Of Contents
- CHAPTER00
- CHAPTER01_General_information
- CHAPTER02_Model_selection
- 1. MODEL SELECTION PROCEDURE
- 2. MODEL LINE UP
- 3. MODEL SELECTION AND CAPACITY CALCULATION
- 4. CAPACITY TABLE COOLING (OUTDOOR UNIT)
- 5. CAPACITY TABLE HEATING (OUTDOOR UNIT)
- 6. CAPACITY COMPENSATION COEFFICIENT
- 7. CAPACITY TABLE COOLING (INDOOR UNIT)
- 7-1. COMPACT CASSETTE TYPE
- 7-2. CIRCULAR FLOW CASSETTE TYPE
- 7-3. CASSETTE TYPE
- 7-4. MINI DUCT TYPE
- 7-5. SLIM DUCT / SLIM CONCEALED FLOOR TYPE
- 7-6. MEDIUM STATIC PRESSURE DUCT TYPE
- 7-7. HIGH STATIC PRESSURE DUCT TYPE
- 7-8. VERTICAL AIR HANDLER TYPE
- 7-9. COMPACT FLOOR TYPE
- 7-10. FLOOR / CEILING TYPE
- 7-11. CEILING TYPE
- 7-12. WALL MOUNTED TYPE
- 8. CAPACITY TABLE HEATING (INDOOR UNIT)
- 8-1. COMPACT CASSETTE TYPE
- 8-2. CIRCULAR FLOW CASSETTE TYPE
- 8-3. CASSETTE TYPE
- 8-4. MINI DUCT TYPE
- 8-5. SLIM DUCT / SLIM CONCEALED FLOOR TYPE
- 8-6. MEDIUM STATIC PRESSURE DUCT TYPE
- 8-7. HIGH STATIC PRESSURE DUCT TYPE
- 8-8. VERTICAL AIR HANDLER TYPE
- 8-9. COMPACT FLOOR TYPE
- 8-10. FLOOR / CEILING TYPE
- 8-11. CEILING TYPE
- 8-12. WALL MOUNTED TYPE
- CHAPTER03_Outdoor_units
- CHAPTER04_Indoor_units
- CHAPTER05_Control_system
- 1. CONTROL SYSTEM
- 2. CONTROL UNITS
- 2-1. SYSTEM CONTROLLER
- 2-2. SYSTEM CONTROLLER LITE
- 2-3. TOUCH PANEL CONTROLLER
- 2-4. CENTRAL REMOTE CONTROLLER
- 2-5. WIRED REMOTE CONTROLLER (Touch panel)
- 2-6. WIRED REMOTE CONTROLLER
- 2-7. SIMPLE REMOTE CONTROLLER (With Operation mode)
- 2-8. SIMPLE REMOTE CONTROLLER (Without Operation mode)
- 2-9. WIRELESS REMOTE CONTROLLER
- 2-10. IR RECEIVER UNIT (for ALL DUCT TYPE)
- 2-11. IR RECEIVER UNIT (for CASSETTE TYPE)
- 2-12. IR RECEIVER UNIT (for CIRCULAR FLOW CASSETTE TYPE)
- 2-13. HUMAN SENSOR KIT (for CIRCULAR FLOW CASSETTE TYPE)
- 2-14. REMOTE SENSOR UNIT
- 2-15. PRESSURE SENSOR KIT
- 2-16. GROUP CONTROL METHOD
- 2-17. COMPARISON TABLE OF CONTROLLERS
- 3. ADAPTOR / CONVERTOR UNITS
- 4. SERVICE & WEB MONITORING TOOL
- CHAPTER06_System_design
- CHAPTER07_Function_setting
- CHAPTER08_External_input_and_output
- CHAPTER09_Notes
- CHAPTER10_Optional_parts
- CHAPTER99
When performing periodical settings like schedule settings for the following functions, perform the setting to all the
indoor units in the same refrigerant system simultaneously, conforming to the timing restriction described below.
<Corresponding function>
More than 10 minutes must elapse
More than 10 minutes must elapse
· Stop operation
· Set indoor unit forced thermostat
o mode
· Start operation
· Release indoor unit forced
thermostat o mode
Forced thermostat OFF instruction, outdoor unit forced o instruction and capacity save setting.
Only one equipment can send these instructions for each refrigerant system.
When these instructions are sent by multiple equipment (eg.from System Controller & BACnet
®
Gateway at the
same time), the system may not respond as instructed or may malfunction.
The electricity charge apportionment function of VRF system can only be performed from one equipment simultaneously.
Therefore, ECA setting, required to be set before performing electricity charge apportionment, can only be sent from one
equipment simultaneously.
The energy saving function of VRF system can only be performed from one equipment simultaneously. Therefore, ES
setting, required to be set before performing energy saving, can only be sent from one equipment simultaneously.
PACKING LIST
Name and shape Quantity Application
WHITE-USB-KEY
(software
protection key with software)
1
Includes the software and manuals for Web Monitoring Tool.
Additionally, it works as the software protection key.
Software protection key to be connected to an USB port on the PC
that the Web Monitoring Tool is installed. Web Monitoring Tool runs
only on a PC with this WHITE-USB-KEY.
OTHER REQUIRED DEVICES (Locally purchased)
● Personal computer that satisfies the following system requirements
● Echelon
®
U10 USB Network Interface – TP/FT-10 Channel (Model number: 75010R) (Required
for each VRF Network.)
PERSONAL COMPUTER SYSTEM REQUIREMENTS
Operating system
• Microsoft
®
Windows
®
7 Home Premium (32-bit or 64-bit) SP1
• Microsoft
®
Windows
®
7 Professional (32-bit or 64-bit) SP1
• Microsoft
®
Windows
®
8.1 (32-bit or 64-bit)
• Microsoft
®
Windows
®
8.1 Pro (32-bit or 64-bit)
• Microsoft
®
Windows
®
10 Home (32-bit or 64-bit)
• Microsoft
®
Windows
®
10 Pro (32-bit or 64-bit)
[Supported languages]
English, Chinese, French, German, Russian, Spanish, and Polish
CPU Intel
®
Core
TM
i3 2 GHz or higher
Memory • 2 GB or more (for Windows
®
7 [32-bit])
• 4 GB or more (for Windows
®
7 [64-bit], Windows
®
8.1, and Windows
®
10)
HDD 40 GB or more of free space
Display 1,024 × 768 or higher resolution
Interface
• Ethernet port (for getting access to the Internet using LAN)
• USB ports (Maximum of 5 ports)
- 1 USB port is required for WHITE USB-Key connection
- Maximum of 4 USB ports are required for Echelon
®
U10 USB Network Interface
* Maximum number of required USB ports depends on the applicable system congurations.
Software Adobe
®
Reader
®
9.0 or later
- (05 - 164) -
CONTROL
SYSTEM
CONTROL
SYSTEM