Design Technical Manual

Table Of Contents
Unit : in. (mm)
Caution
Use 3/16 (5) self tapping screws having a thread length of 3/8 (10) to 13/16 (20).
Remove ONLY the screws that are highlighted with a circle on the next page.
Drill holes in dowels ONLY where highlighted with a circle on the next page, otherwise damage to
the unit could occur.
SNOW HOOD INSTALLATION PROCEDURE
z
Installing the upper part of snow hood
The upper part of the snow hood can be installed in the same manner as the Discharge
Duct previously described. See Discharge Duct Installation Procedure.
z
Installing the sides of snow hood
Before installing the snow hood, remove the screws that keep the screen in place.
Remove screen.
Install the snow hood using the screws holes shown in the gure on the next page.
Remove the screws that are highlighted with a circle on the next page and drill a 3/16 (4.6)
hole in each dowel.
- (03 - 37) -
OUTDOOR
UNITS
OUTDOOR
UNITS