Design and Technical Manual

6. SYSTEM DESIGN
FUNCTION SETTING

(5) Press the “MODE” button to access the
function setting mode.
(6) Press the “
p
” or the “
q
” buttons to select
the function number.
Each time the “MODE” button is pressed, it
switches between the one's place and the ten's
place positions.
Change digit
(7) Press the FAN button to proceed to setting
the number. (Press the FAN button again
to return to the function number selection.)
(8) Press the “
p
” or the “
q
” buttons to select
the setting number.
Each time the “MODE” button is pressed, it
switches between the one's place and the ten's
place positions.
Change digit
(9) Press the “TIME MODE” button once to
send the function mode information.
Pi Pi
(10) Press the “START/STOP” button once to
send the function setting information.
A beeping noise will be heard if the
command is accepted.
*Wrong code: No Response
Pi Pi
Note: Please push "START/STOP" button within 30
seconds after pushing "TIME MODE" button.
FUNCTION DETAILS

Refer to 5-6. FUNCTION DETAILS
- (06 - 58) -
SYSTEM DESIGN SYSTEM DESIGN