Design and Technical Manual

6. SYSTEM DESIGN
To the opposite side
Control box
Remove the control
box by lifting up and
out through slots
Insert and x the control
box using the slots
The lead wire
runs here
(5) Remove the control box as shown in the gure,
and then change the positioning to the opposite
side.
(6) Attach the control box to the main unit as
shown in the gure.
Control box
Bottom panel
(7) Attach the bottom panel and secure it with the
screws (4 pieces).
(8) Secure the control box with the screws
(4 pieces).
Control box
Control box cover
Seal
(Accessory)
Af x the seal so each hole
(4 places) is covered
Wiring cover
Secure the wiring
cover by inserting into
the slots
(9) Attach the control box cover and secure it with
the screws (2 places).
(10) Attach the wiring cover and secure it with the
screws (2 places).
Afx the seals on the main unit (4 places).
- (06 - 32) -
SYSTEM DESIGN SYSTEM DESIGN