Design and Technical Manual

5. CONTROL SYSTEM
REMOTE SENSOR UNIT2-6.
MODEL : UTY - XSZX

FEATURES

New amenity space can be offered by installing the Remote sensor.
ELECTRICAL WIRING

Remove the screws from the remote sensor, and remove the cover. ●
Connect the cable to the remote sensor as shown below. ●
Ensure that the wires do not contact each other. ●
Remote sensor
To indoor unit
Cable
INSTALLATION

When the cable is attached to the wall

Remove the material covering the wiring penetration (thin material) in the cover of the sensor ●
unit with a pair of cutters. The cable passes through this hole.
Now the remote sensor on the wall using the screws. ●
1-9/16
(
40
)
2-3/16
(
55
)
Screw
(M4 x 16mm)
[Unit : in.(mm)]
Mounting hole dimensions
- (05 - 41) -
CONTROL SYSTEM CONTROL SYSTEM