Design and Technical Manual

5. CONTROL SYSTEM
Pattern C

1) Modify the remote controller cable as per below methods.
Use a tool to cut off the terminal on the end of the remote controller cable and then remove ●
the insulation from the cut end of the cable as shown in Fig.
Connect the remote controller cable and connecting cable as shown in Fig. ●
Be sure to insulate the connection between the cables. ●
13/16 in. (20 mm)
Remote controller
cable
Connecting
cable
Insulated
connection
Red
Red
White
White
Black
Black
2) Method of connecting remote controller cable
Connecting cable made by above-mentioned 1) is connected with PCB of Indoor unit. ●
Remote controller
cable
Connecting
cable
Indoor unit PCB
- (05 - 23) -
CONTROL SYSTEM CONTROL SYSTEM