Design and Technical Manual

6. SYSTEM DESIGN
Chamber installation
z
Fit the four-sided holes of the chamber together with the hook ttings of the Fresh Air Intake
Kit (in two places), and secure the attached chamber in place with screws provided.
Ø3-15/16 (100)
hook fittings
screw x 2
Unit : in. (mm)
When using the “UTZ-KXGC” kit for high humidity, please first cut off and remove the heat ●
insulation as shown in the figure.
Please install the kit for high humidity according to the installation instruction sheet provided. ●
Cut off
3-1/8 (80)
1-3/16 (30)
- (06 - 137) -
SYSTEM DESIGN SYSTEM DESIGN