Design and Technical Manual

6. SYSTEM DESIGN
FUNCTION SETTING

3) Press the FAN button so that the "Function number" display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to set up the function number.
Function number
4) Press the FAN button so that the "Setting number" display ashes. Then, press either the
SET TEMP.
p
button or the SET TEMP.
q
button to set up the setting number.
Ex.) Function number : 30, Setting number : 01
Setting number
5) Pressing the START/STOP button, conrm the setting.
(The data will be transferred to the indoor unit.)
NOT GOOD
When the data was normally set up on the indoor
unit.
When the data was not set up on the indoor ●
unit (-- is displayed.)
Set up the data again according to the ●
procedure in step 3), 4) above.
GOOD
FUNCTION DETAILS

Refer to 5-6. FUNCTION DETAILS
- (06 - 77) -
SYSTEM DESIGN SYSTEM DESIGN