Design and Technical Manual

6. SYSTEM DESIGN
FUNCTION SETTING

After verifying that the system is normally, press the MODE/EXIT button (SW931) once.1)
LED961 LED962
LED961 LED962
Press the SELECT button (SW932), and display “F2” on the LED962.2)
LED961 LED962LED961 LED962 LED961 LED962 LED961 LED962
*1 *1
(Monitoring mode) (Setting mode) (Function mode) (Error history mode)
(The display of the LED962 changes each time when the SELECT button is pressed.)
*1:The “F1”and “F9” modes are used for maintenance, so do not set them in regular operation.
When “F2” appears on the LED962, press the ENTER button (SW933). 3)
A ashing display appears on the LED961, and the ashing display of “F2” on the LED962
changes to the illuminated display of a number.
LED961 LED962
LED961 LED962
Referring to the Settings List shown below, press the SELECT button (SW932) and display the 4)
code number of the mode you want to set on the LED961.
Ex.) To select switching between Forced Stop and Emergency Stop
LED961 LED962
LED961 LED962
Next, press the ENTER button (SW933), and conrm the selection of the mode you want to
set.
A ashing display on the LED961 changes to an illuminated display, and an illuminated display
on the LED962 changes to a ashing display.
LED961 LED962 LED961 LED962
- (06 - 51) -
SYSTEM DESIGN SYSTEM DESIGN