User's Manual
Table Of Contents
- SPARC® Enterprise T5140 and T5240 Servers Installation Guide
- Contents
- Figures
- Tables
- Preface
- Preparing for Installation
- Installing the SPARC Enterprise T5140 and T5240 Servers
- Powering On the System
- Updating the Firmware
- Selecting a Boot Device
- Installing the Servers With the Express Rail Rackmounting Kit
- Index
34 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
Caution – Verify the operation of the slide rails and CMA, and cable service loops.
Perform the steps in the following procedure again before continuing: “To Verify the
Operation of the Slide Rails and the CMA” on page 29.
Dismounting the Servers
To install or replace internal parts in the server, you must first remove the server
from the rack. For the removal procedure, refer to the SPARC Enterprise T5140 and
T5240 Servers Service Manual.