Operation Manual

ManualsBrandsFujitsu ManualseBook ReaderFujitsu Stylistic V535

Troubleshooting and tips

Error messages on the screen

Errormessages onthescr eenErrormessage:

This section describes the error messages generated by the BIO S Setup. Error messages displayed

by the operating system or programmes are described in the relevant documentation.

If the error message appears repeatedly, des pite troubleshooting measures, please

contact the place of purchase or o ur customer service centre.

Error message/cause Resolution

System CMOS checksum bad - default conﬁguration

used

The system conﬁguration information is

incorrect.

► Switch off the Tablet PC.

► Switch on the Tablet PC.

► Keep the volume – button a

nd the shortcut

button pressed and swit

ch the Tablet PC o n.

If you keep the volume –

button pressed,

you can switch into th

e BIOS Setup-

► In the B IOS Setup, select the Exit menu.

► Select the entry Loa

d Setup Defaults.

► Select OK and press the Enter key.

Keyboard controller error

► Switch off your Tablet PC with the ON/OFF

switch.

► Wait 3 - 5 seconds and switch on the Tab let

PC again.

Keyboard error

If you are using an external keyboard:

► Check the connection and reboot the Tablet

PC.

nn Stuck key

► Make sure that no key is pressed.

Operating system not found

► Check in the B

IOS Setup whether your hard

disk has been

set correctly.

► Make sure that the operating system is

installed on the corresponding drive.

Press < F1> to resume, <F2> to SETUP

This error message appears if an error occurs

during the self-test before starting the operating

system.

► Press the

Alt

key on the Tablet PC to boot

the operating system

Real time clock error