Operation Manual

Using the Tablet PC
To attach the pen to your Tablet PC, perform the following steps:
► Attach the end of the retention cord to the attachment point on your Tablet PC (2) with the loop.
► Attach the end of the retention cord to your pen (3) with the loop.
Replacing the pen tip
With use, the pen tip may become worn or may pick up foreign particles that can scratch the screen.
A damaged or worn tip may not move freely, causing unpredictable results when using the pen.
If your pen exhibits these problems, you should replace the pen tip. To do so, use the pen tip
removal tool included with your pen.
Pen tips are available as an accessory from your authorised Wacom dealer (www.wacom.com).
1
2
1
► To remove the tip; position the tip in the
gap between the two ends of the tip
changer.
► Pinch the tool together so that the tip is
firmly clamped (1), then pull it from the
barrel (2).
► To replace the tip, retrieve one of the new
tips that were supplied your pen.
Insert the flat end of the tip into the barrel
and push it in firmly until it is in place.
i
If the tip is worn or damaged, discard it.
32 A26391-K222-Z121-1-7619, edition 2