Operation Manual

Security functions
Activating hard disk protection
► Call up the BIOS Setup and select the Security menu.

If you have not assigned BIOS passwords yet, define the supervisor and the user
password now, if desire d (see "
Securit y fun ctions", Page 61).
► Mark the Hard Disk Security fie ld and press the Enter key.
► In the Drive0 area mark the Set Master Password field and press the Enter key.

Enter new Password then appears and you are asked to enter a password.
► Ente r the password and press the Enter k ey.

Confirm new Password requires you to co n firm the password.
► Ente r the pa ssword again and press the En ter key.

Setup Notice: Changes have been sav ed is displayed to confirm that the
new password has been saved.
The field Password Entry on Boot is set to Enabled by default. You can exit the BIOS
Setup once you have finished changing the settings.
► From the Exit menu, choose t he option Exit Saving Changes.
► Press the Enter k ey and select Ye s.

The Table PC reboots and your hard disk is now protected with a password. The
password prompt is enabled as soon as the Tablet PC has rebooted.
Deactivating hard disk protection
To cancel a password without setting a new one, proceed as follows:
► Call up the BIOS Setup and select the Security menu.
► Mark the Hard Disk Security fie ld and press the Enter key.
► In the Drive0 area mark the Set Master Password field and press the Enter key.

You will be initially requested to en ter the old p assword by the Enter current Password prompt.
You will then be requested to enter a new password by the Enter n ew Password prompt.
► Afte r entering the password, press the Enter key three time s.
► From the Exit menu, choose t he option Exit Saving Changes.
► Press the Enter k ey and select Ye s.

The Tablet PC reboots and there is no longer any password protection for this hard disk.
66 Fujitsu