Operation Manual
Table Of Contents
- FUJITSU Tablet STYLISTIC Q584
- Contents
- Innovative technology
- Ports and controls
- Important notes
- First-time setup of your device
- Working with the Tablet PC
- Battery charging indicator
- Switching on the Tablet PC
- Switching off the Tablet PC
- Handwriting recognition
- Touchscreen
- Select display orientation (portrait or landscape orientation)
- Using fingers
- Using the stylus pen
- Tablet buttons
- Webcam
- Rechargeable battery
- Using the power-management features
- Memory cards
- SIM card
- Wireless LAN/Bluetooth/UMTS/LTE/NFC radio components
- Ethernet and LAN (only with Multi-functional Cradle)
- GPS
- Accessories for your Tablet PC (optional)
- Security functions
- Connecting external devices
- Settings in BIOS Setup Utility
- Starting the BIOS Setup Utility
- Operating BIOS Setup Utility
- Exiting BIOS Setup Utility
- Exit Saving Changes - save changes and exit BIOS Setup Utility
- Exit Discarding Changes – Discard changes and exit BIOS Setup Utility
- Load Setup Defaults – Copy Standard Entries
- Discard Changes – Discard changes without exiting the BIOS Setup Utility
- Save Changes - save changes without exiting the BIOS Setup Utility
- Save Changes and Power Off
- Troubleshooting and tips
- Help if problems occur
- The Tablet PC's date or time is incorrect
- Battery indicator does not illuminate
- The Tablet PC's touchscreen remains dark
- The display on the Tablet PC's touchscreen is difficult to read.
- The external monitor remains blank
- The external monitor is blank or the image is unstable
- The cursor does not correctly follow the pen movements
- Pen input not working
- The Tablet PC does not start after switch on
- The Tablet PC stops working
- The printer does not print
- The radio connection to a network does not work
- The battery discharges too quickly
- SmartCard reader is not recognised
- SmartCard PIN forgotten
- User and/or supervisor SmartCard lost
- SmartCard lost
- Acoustic warnings
- Error messages on the screen
- Technical data
- Manufacturer’s notes
- Index
Troubleshooting and tips
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost flat.
► Charge the battery.
Error messages on the screen
Errormessages onthesc
reen
Errormessage:
This section describes the error messages g enerat ed by the BIOS Setup. Error messages displayed
by the operating system or programmes are describ ed in the relevant docu mentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/c ause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch off the Tablet PC.
► Switch on the Tablet PC.
► Keep the volume – and sho rtcut buttons
pressed and switch the Tablet PC on. When
you boot while pressing the volume – button,
you c an switch to the BIO S Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
Extended memo r y failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory an error has
resulted at the address xxxx.
► Contact you
r sales outlet or our customer
service cen
tre.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the
BIOS Setup (Primary Master
submenu)
and select the correct settings.
Keyboard controller error
► Switch
off y our Tablet PC with the power
button
.
► Wait 3 - 5 s econds and switch on the Tablet
PC again.
Keyboard error
If you are using an e xternal keyboard:
► Check the connection and rebo ot the Tablet
PC.
nn Stuck key
► Make sure that no key is pressed.
Fujitsu 79