Operation Manual

Instructies van de fabrikant
Regelgevingsbekendmakingen
If there is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Commun ications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel the US trading area ca rrying this
device, but to avoid trouble at customs clearance Fujitsu Technology Solutions
GmbH recommends not to bring this device into the US trading are a.
Regulatory information f
or Tablet PCs without radio device
Regulatoryinform ation
NOTICE:
Changes or modications no t expressly approved by F ujitsu Technology Solutions
could v oid this user’s authority to operate the equipment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interferen ce in a
residential installation. Th is equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no g u arantee that interference w ill not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the e quipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate th e receiving antenna.
Increase the sep
aration between the equipment and receiver.
Connect the equipment into an outlet that is on a different circuit than the receiver.
Consult the dea
ler or an expe rienced radio/TV technician for help.
Notice to Users of t he U S Telephone Network
Your Tablet PC m ay be supplied with an internal modem which complies with Part 68 of the
FCC rules. On this Tablet PC is a label that contains the FCC Registration Number and the
Ringer Equivalence Number (REN) for this equipment among other information. If requested,
the user must provide their telephone company w ith the following information:
1. The telephon e number to which the Tablet PC is conne cted .
2. The Ringer
Equivalence Number (REN) for this equipment.
3. The equipment requires a standard modular jack type USOC RJ-11C
which is FCC Part 68 co mpliant.
4. The FCC Re
gistration Number.
This equipment is designed to be connected to the telephone network or premises wiring using
a sta ndard modular jack type USOC RJ-11C which is FCC Part 68 compliant and a line cord
between the modem and the telephone network with a minimum of 26AWG.
The REN is used to determine the number of devices that you may connect to your telephone
line and still have all of those devices ring when your number is called. Too many devices
on one line may result in failure to ring in response to an incoming call. In most, but not all,
areas the sum of the RENs of all of the devices should not exceed ve (5). To be certain
of the number of devices you may connect to your line, as determined by the RENs, contact
your local telephone company. If this equipment causes ha rm to the telephone network, your
telephone c ompa ny may discontinue your service temporarily. If possible, they will notify you
in advance. If advance notice is not practical they will notify you as soon as possible. You
will also be advised of your right to le a complaint with the FCC.
86 Fujitsu