Instruction Manual

Manufacturer’s notes
For Au th orized Repair Tec hni cians Only
CAUTION:
For continued protection against risk of fire, replace only with the
same type and rating fuse.
WA RNING:
Danger of explosion if Lit
hium (CMOS) battery is incorrectly replaced . Replace only
with the same or e quivalen
t type recommended by the manufacturer.
Dispose of used batterie
s according to the manufacturer’s instructions.
FCC Regulatory information
Regulatoryinformation
Federal Communicatio ns Commission statem ent
This device complies with Part 15 of FCC Rules. Operation is subject to the follow ing
two conditions: (1) this device may not cause interference, and
(2) this de vice must accept any interference, including interference that may
cause undesired operation of this device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, p ursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interferenc e will not occur in a particular installation.
If this equipment d oes cause harmful interference to radio or television reception, w hich
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving ant enna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Please note the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated under FCC Bulletin O ET 65C and found comp liant with th e
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF
Exposure from radio frequency devices. The radiated output power of this radio device is far below
the FCC radio frequency e xposure limits. Nevertheless, this device shall be used in such a m anner
that the potential for human contact during normal operation is minimized. When using this d evice, a
certain separation distance between antenna an d nearby persons must be maintained to ensure RF
exposure comp liance. In ord er to comply with R F exposure limits established in the ANSI C95.1
standards, the distance between the antennas and the user should not be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and auth orizatio n fo r use
Fujitsu 85