Instruction Manual

Troubleshooting and tips
Acoustic warning
Acous ticwa rningsErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost flat.
► Charge the battery.
Error messages on the screen
Errormessages onthesc
reen
Errors
This section describes the error messages generated by the BIO S Setup. Error messages displayed
by the operating system or programs are described in the d ocumentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service c enter.
Error message/cause Troub lesho oting
CMOS Battery Bad
If the e rror message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
► Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► Keep the volume button and the shortcut
button pressed and switch the Tab let PC
on. If you keep the volume butt on pressed
during the boot process, you can switch into
the BIOS Setup-
► In the B IOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
► Contact you
r sales outlet or our customer
service cen
ter.
Failure Fixed Disk n
The s ettings of the hard disk drive are incorrect.
► Start the
BIOS Setup (Prim ary Master
submenu
) and select the correct settings.
Keyboard controller error
► Switch
your Tablet PC off with the ON/OF F
butto
n.
► Wait 3 - 5 seconds and switch the Tablet PC
on again.
Keyboard error
If you use an external keyboard:
► Check the connection and reboot the Tablet
PC.
nn Stuck key
► Make sure that no key is pressed.
76 Fujitsu