Instruction Manual

Security functions
Changing the supervisor HDD password or user HDD password
You can only change the supervisor HDD password when you have logged into the
BIOS S etu p Utility with the supervisor HDD password.
PasswordSupervisorHDDpasswordUserHDDpassword
► Start the B IOS Se tu p Utility and go to the Security menu.
► When changing the p assword, proceed exactly as w hen assigning a password.
Removing passwords
To remove a password (without setting a new password) perform the following steps:
PasswordSupervisorpasswordUser password
► Start the B IOS Se tu p Utility and go to the Security menu.
► Highlight the Set Supervisor Password or Set User Password field and press the Enter key.

You w ill be requested to enter the current password by the Enter Current Password prompt.
Enter New Password will appear and you will be requested to enter a new passw ord.
► Press the Enter key twice at this reque st.
► In the Exit menu, select the option Save Changes & Exit.
► Select Yes and press the Enter key.

The Ta blet PC is rebooted and the password is removed.
Removing the supervisor password simultaneously deactivates the user password.
Password protection for booting the operating system
You can also pre
vent booting of the operating system with the supervisor
HDD password yo
uhavesetintheBIOS Setup Utility (see s ecti on "
Assigning
the superviso
r and user passwords", Page 58).
Operating system
Activating system protection
► Start the B IOS Se tu p Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select the option you require (Disabled, First Boot or Every Boot) and press the enter key
► Select the Save Changes & Exit option under Exit.

The Tab let PC reboots. You will be prompted to enter your password (the supervisor passw ord).
Deactivating system protection
► Start the B IOS Se tu p Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select the Disabled option and p ress the Enter key.

If you d o not want to change any other settings, you can exit BIOS Setup Utility.
► Select the Save Changes & Exit option under Exit.

The Ta blet PC reboots. The system is no longer password -protected.
Fujitsu 59