User Guide

4-6 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
4.2 Example: Adding a System Board
This section provides an example of the DR operation to add a system board to a
domain. In the example, a procedure conforming to section <LinkColor>4.1.1, "Flow:
Adding a System Board.", is used, and the system board shown in the figure is
added by using the XSCF shell.
FIGURE 4-5 Example: Adding a System Board
1. Login to XSCF.
2. Check the status of the domain.
Execute the showdcl(8) command to display domain information, and then
check the operation status of the domain. Based on the operation status of the
domain, determine whether to perform the DR operation or change the domain
configuration.
3. Check the status of the system board to be added.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be added and confirm its registration
in the DCL.
XSCF> showdcl -d 0
DID LSB XSB Status
00 Running
00 00-0
01 01-0
Domain#0
XSB#00-0
XSB#01-0
Add
Domain#0
XSB#00-0
XSB#01-0