Technical data

TX300 S5 Operating manual 49

Hardware installation Installing/removing the rack model

Inserting the server

V CAUTION!

At least two people are needed to position the server in the rack.

Figure 5: Inserting the server

Ê Pull the mounted support systems forwards as far as they will go until they

engage. The telescopic rails must not be able to move backwards any more.

Ê Lift the server onto the left and right system support rods (1).

V CAUTION!

Hold the server on both sides when lifting it onto the left and right

system support rods, not just by the handles on the front panel!

Ê Slide the server slightly in the direction of the arrow (2) until the hooks

engage. When doing this, ensure that the telescopic rails are kept in a locked

position.

Ê Fasten the server to the left and right system support rods (3) using one

M3x6 screw on each side.