Technical data

110 Operating manual TX300 S5
Non-hot-plug components CSS components
Figure 39: Installing an expansion card
Ê Carefully press the new expansion card into the relevant slot on the system
board (1) until it clicks into place.
Ê Fit the clip onto the slot cover so that the pin fits into the hole.
Ê Push the clip under the metal nose until it clicks into place.
Ê Swing the lever (2) downwards into its locking position.
Ê Reconnect all cables to the expansion card.
Ê Replace the left side cover (floorstand model) or the housing cover (rack
model) (see section "Opening/closing the housing" on page 111).
2
1