Datasheet

System configurator and order-information guide
F
PRIMERGY RX300 S7 Status 2014-03-31
S26361-F3694-E10
Independent Mode
Independent Channel Mode allows all channels to be populated in any order. No specific Memory RAS features are defined
Requires min 1 memory Module per CPU
S26361-F3694-E1 Rank Sparing Mode Installation
BIOS Setup factory preinstalled to this mode. One Rank is spare of other ranks on the same channel. Spare Rank is not shown in System Memory.
For effective capacity within a channel, please have a look below.
Supported for RDIMM / LRDIMM only.
1x per CPU Requires min 2x 1R/2R or 1x 4R modules per CPU
S26361-F3694-E2 Performance Mode Installation
BIOS Setup factory preinstalled for max. Performance, LV memory might be set to 1.5V operation. Four identical memory modules
will be equipped in one memory bank to achieve highest memory performance. All four modules are active and full capacity can be used.
Multiple of 4 identical modules to be configured per CPU
S26361-F3694-E3
Mirrored Channel Mode Installation
BIOS Setup factory preinstalled to this mode. Four identical memory modules are always equipped in one memory bank to use the
Mirrored channel Mode. Only two modules contain active data, the remain two modules contain mirrored data
Supported for RDIMM / LRDIMM only.
Multiple of 4 identical modules to be configured per CPU
1R
2R
1R
2R
4R
4R
na na na na na
na na
na na
Minimum one memory module or order code per CPU = first memory
Note 1.)
Unbuffered Memory (UDIMM) no SDDC (chipkill) support
Max. DDR3 memory speed depends on the memory configuration
- one DDR3 unbuffered ECC mem. Module, 1.35V
(No of mem modules per channe) as well as on the CPU type.
Choose up to 8 order codes per CPU The memory channel with the lowest speed defines the speed
2GB (1x2GB) 1Rx8 L DDR3-1600 U ECC S26361-F3694-E513 of all CPU channels in the system, also for the channels of the
4GB (1x4GB) 2Rx8 L DDR3-1600 U ECC S26361-F3694-E514 second CPU if configured.
Registered Memory (RDIMM) no SDDC (chipkill) support For real memory speed (depending on memory type / population),
- one DDR3 registered ECC mem. Module, 1.35V please check the spreadsheet "Memory speed" below
No mix with any other types of memory modules possible
Choose up to 12x for 1R/2R or 8x for 4R per CPU
For performance reasons, we do not recommend
to configure more than 8 DIMMs per CPU
4GB (1x4GB) 2Rx8 L DDR3-1600 R ECC S26361-F3695-E514
Registered Memory (RDIMM) with SDDC (chipkill) support
8/12x per - one DDR3 registered ECC mem. Module, 1.35V Mix of memory modules is only possible within the same group
CPU, max. 1333MHz supported with up to 2DPC (8 modules/CPU)
2/3 modules Choose up to 12 order codes per CPU
per channel 4GB (1x4GB) 1Rx4 L DDR3-1333 R ECC S26361-F3696-E514 new due to supply
8GB (1x8GB) 2Rx4 L DDR3-1333 R ECC S26361-F3696-E515 new due to supply
Registered Memory (RDIMM) with SDDC (chipkill) support
- one DDR3 registered ECC mem. Module, 1.35V
1600MHz supported with up to 2DPC (8 modules/CPU)
at 1.5V
Choose up to 12 order codes per CPU
4GB (1x4GB) 1Rx4 L DDR3-1600 R ECC S26361-F3697-E514
8GB (1x8GB) 2Rx4 L DDR3-1600 R ECC S26361-F3697-E515
16GB (1x16GB) 2Rx4 L DDR3-1600 R ECC S26361-F3697-E516
Load Reduced Memory (LRDIMM) with SDDC (chipkill) support
- one DDR3 load reduced ECC mem. Module, 1.35V
Choose up to 12 order codes per CPU
16GB (1x16GB) 4Rx4 L DDR3-1333 LR ECC S26361-F3698-E516
32GB (1x32GB) 4Rx4 L DDR3-1333 LR ECC S26361-F3698-E517
G
Effective Memory capacity / Rank Sparing Mode, 1 Channel populated
UDIMM
RDIMM
LRDIMM
2GB
2GB
4GB
8GB
2R
16GB
16GB
32GB
1DPC
12GB
24GB
2DPC
4GB
12GB
24GB
28GB
56GB
3DPC
8GB
20GB
40GB
40GB
80GB
Fujitsu PRIMERGY Server 13 of 31