System information

RX2520 M1 Upgrade and Maintenance Manual 277
Front panel and external connectors
Figure 176: Connecting front panel cables
Ê Connect the front panel cable to the system board.
Ê Run the front panel cable through the cable clamps as shown.
Ê If applicable, connect the front VGA cable to the front VGA connector of the
system board as described in section "Installing the front VGA connector" on
page 278.
13.1.1.4 Concluding steps
Ê "Installing the fan box" on page 146
Ê "Reassembling" on page 57
Ê "Connecting the server to the power source" on page 62
Ê "Switching on the server" on page 64
Ê "Verifying system information backup / restore" on page 75
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 91.