System information

166 Upgrade and Maintenance Manual RX2520 M1
Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing the slot bracket" on
page 160.
9.3.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 153.
Ê "Installing expansion cards" on page 159.
Ê If applicable, "Installing SFP+ transceiver modules" on page 186.
9.3.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 331.
9.3.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 174.
9.3.3.6 Concluding steps
Ê "Reassembling" on page 57
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 62
Ê "Switching on the server" on page 64
Ê "Enabling replaced components in the system BIOS" on page 82
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 89.
Ê "Updating RAID controller firmware" on page 77
Ê "Enabling SVOM boot watchdog functionality" on page 82
Ê "Enabling BitLocker functionality" on page 88