Operation Manual
Table Of Contents
- Contents
- 1 Preface
- 2 Installation steps, overview
- 3 Important information
- 4 Hardware installation
- 5 Starting up and operation
- 5.1 Access to the drives (floorstand model)
- 5.2 Control elements and indicators
- 5.3 Switching the server on and off
- 5.4 Configuring the server
- 5.4.1 Configuring the onboard SATA controller
- 5.4.2 Configuring the SAS/SATA RAID controller
- 5.4.3 Configuring the server and installing the operating system with the ServerView Installation Manager
- 5.4.4 Configuring the server and installing the operating system without the ServerView Installation Manager
- 5.5 Cleaning the server
- 6 Property and data protection
- 7 Troubleshooting and tips
- 7.1 Power-on indicator remains unlit
- 7.2 Server switches itself off
- 7.3 Screen remains blank
- 7.4 Flickering stripes on monitor screen
- 7.5 No screen display or display drifts
- 7.6 No mouse pointer displayed on screen
- 7.7 Incorrect date and time
- 7.8 Drives reported as “dead” when starting system
- 7.9 Added drive reported as defective
- 7.10 Error message on screen
- 7.11 Expansion cards or onboard devices not recognized
- 7.12 Temperature warning
- 7.13 No effect of keyboard or mouse
- 7.14 Optical drive cannot read data
- 8 CSS components
- 8.1 Hot-plug components
- 8.2 Non-hot-plug components
- 9 Appendix: server specification
- Index
TX150 S7 Operating Manual 89
CSS components Hot-plug components
8.1 Hot-plug components
This section describes how to handle hot-plug components and how to modify
your server hardware (e.g. adding/replacing hot-plug power supply units).
The hot-plug procedure increases the availability of system operation and
guarantees a high degree of data integrity and failsafe performance.
8.1.1 Hot-plug power supply units (optional)
With two hot-plug power supply units installed, if a defect occurs in one power
supply unit, the other power supply unit ensures unimpaired further operation.
The defective power supply unit can be replaced during operation (hot-plug).
V CAUTION!
● Areas around the power supply unit may remain extremely hot after
shutdown. Wait for a while after shutdown before removing the power
supply unit.
● When installing the power supply unit, be sure to confirm that the
connector of the PSU is not damaged or bent.
● Do not insert your hands in the power supply unit slot when removing
the power supply unit. Doing so may cause electric shock.
● If the power supply unit is hard to remove, do not pull out it by force.
Slide the power supply unit all the way down once,and then remove
it while holding the lever completely down.
● The power supply unit is heavy, so handle it carefully.If you drop it by
mistake, injuries may result.