Operation Manual
Table Of Contents
- Contents
- 1 Preface
- 2 Installation steps, overview
- 3 Important information
- 4 Hardware installation
- 5 Starting up and operation
- 5.1 Access to the drives (floorstand model)
- 5.2 Control elements and indicators
- 5.3 Switching the server on and off
- 5.4 Configuring the server
- 5.4.1 Configuring the onboard SATA controller
- 5.4.2 Configuring the SAS/SATA RAID controller
- 5.4.3 Configuring the server and installing the operating system with the ServerView Installation Manager
- 5.4.4 Configuring the server and installing the operating system without the ServerView Installation Manager
- 5.5 Cleaning the server
- 6 Property and data protection
- 7 Troubleshooting and tips
- 7.1 Power-on indicator remains unlit
- 7.2 Server switches itself off
- 7.3 Screen remains blank
- 7.4 Flickering stripes on monitor screen
- 7.5 No screen display or display drifts
- 7.6 No mouse pointer displayed on screen
- 7.7 Incorrect date and time
- 7.8 Drives reported as “dead” when starting system
- 7.9 Added drive reported as defective
- 7.10 Error message on screen
- 7.11 Expansion cards or onboard devices not recognized
- 7.12 Temperature warning
- 7.13 No effect of keyboard or mouse
- 7.14 Optical drive cannot read data
- 8 CSS components
- 8.1 Hot-plug components
- 8.2 Non-hot-plug components
- 9 Appendix: server specification
- Index
TX150 S7 Operating Manual 43
Hardware installation Setting up the floorstand model
4.2 Setting up the floorstand model
I If you are not installing a PRIMERGY TX150 S7 floorstand model, skip
this section and continue reading at section "Installing/removing the rack
model" on page 45.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section "Unpacking the server").
Ê Set up the server.
I Note that on floorstand models with hot-plug power supply units, for
safety reasons (risk of tipping) the anti-tilt bracket supplied must be
fitted on the rear of the server (see section "Mounting the anti-tilt
bracket" on page 44).
V CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 55 and "Notes on connecting/disconnecting cables" on
page 58.
Ê Connect the server to the mains (see section "Connecting the server to the
mains" on page 56).