Operation Manual
Table Of Contents
- Contents
- 1 Preface
- 2 Installation steps, overview
- 3 Important information
- 4 Hardware installation
- 5 Starting up and operation
- 5.1 Access to the drives (floorstand model)
- 5.2 Control elements and indicators
- 5.3 Switching the server on and off
- 5.4 Configuring the server
- 5.4.1 Configuring the onboard SATA controller
- 5.4.2 Configuring the SAS/SATA RAID controller
- 5.4.3 Configuring the server and installing the operating system with the ServerView Installation Manager
- 5.4.4 Configuring the server and installing the operating system without the ServerView Installation Manager
- 5.5 Cleaning the server
- 6 Property and data protection
- 7 Troubleshooting and tips
- 7.1 Power-on indicator remains unlit
- 7.2 Server switches itself off
- 7.3 Screen remains blank
- 7.4 Flickering stripes on monitor screen
- 7.5 No screen display or display drifts
- 7.6 No mouse pointer displayed on screen
- 7.7 Incorrect date and time
- 7.8 Drives reported as “dead” when starting system
- 7.9 Added drive reported as defective
- 7.10 Error message on screen
- 7.11 Expansion cards or onboard devices not recognized
- 7.12 Temperature warning
- 7.13 No effect of keyboard or mouse
- 7.14 Optical drive cannot read data
- 8 CSS components
- 8.1 Hot-plug components
- 8.2 Non-hot-plug components
- 9 Appendix: server specification
- Index
114 Operating Manual TX150 S7
Appendix: server specification
Onboard or integrated controllers
Slots
Service LAN (RJ45) 1 x dedicated service LAN port for iRMC S2 (10/100
Mbit/s) Service LAN traffic can be switched to shared
onboard Gbit LAN port
RAID Controller Modular RAID 0/1 controller with "Integrated
Mirroring Enhanced" (SAS IME) for SAS1.0.
RAID levels 0, 1 and 1E are supported for internal
hard disk drive configurations.
Modular RAID 0/1 controller with “MegaRAID
functionality” (SAS MegaRAID) for SAS2.0.
RAID levels 0, 1,10 and 1E are supported for internal
hard disk drive configurations.
Modular RAID 5/6 controller with "MegaRAID
functionality" (SAS MegaRAID) for SAS1.0 and
SAS2.0. RAID levels 0, 1, 10, 1E, 5, 50, 6 and 60 are
supported for internal hard disk drive configurations.
SATA Controller A 6-port SATA controller is integrated on the system
board; up to four SATA hard disk drives can be
connected to the controller. The LSI Embedded
MegaRAID software (SATA Software RAID)
supports RAID levels 0, 1 and 10.
Remote Management
Controller
Integrated Remote Management Controller (iRMC
S2, 32 MB attached memory incl. graphics
controller), IPMI 2.0 compatible
Trusted Platform
Module (TPM)
Infineon / 1.2 (option)
PCI-Express Gen2 x1 2 x
PCI-Express Gen2 x4 1 x Low profile ready, full height, long 3,3 V
PCI-Express Gen2 x8 2 x short 3,3V
PCI 1 x PCI 32/33 MHz, 1x long, 5V
Slot notes in SAS configuration 1x PCI-Express occupied by
modular RAID controller