Operation Manual
Table Of Contents
- Contents
- 1 Preface
- 2 Installation steps, overview
- 3 Important information
- 4 Hardware installation
- 5 Starting up and operation
- 5.1 Access to the drives (floorstand model)
- 5.2 Control elements and indicators
- 5.3 Switching the server on and off
- 5.4 Configuring the server
- 5.4.1 Configuring the onboard SATA controller
- 5.4.2 Configuring the SAS/SATA RAID controller
- 5.4.3 Configuring the server and installing the operating system with the ServerView Installation Manager
- 5.4.4 Configuring the server and installing the operating system without the ServerView Installation Manager
- 5.5 Cleaning the server
- 6 Property and data protection
- 7 Troubleshooting and tips
- 7.1 Power-on indicator remains unlit
- 7.2 Server switches itself off
- 7.3 Screen remains blank
- 7.4 Flickering stripes on monitor screen
- 7.5 No screen display or display drifts
- 7.6 No mouse pointer displayed on screen
- 7.7 Incorrect date and time
- 7.8 Drives reported as “dead” when starting system
- 7.9 Added drive reported as defective
- 7.10 Error message on screen
- 7.11 Expansion cards or onboard devices not recognized
- 7.12 Temperature warning
- 7.13 No effect of keyboard or mouse
- 7.14 Optical drive cannot read data
- 8 CSS components
- 8.1 Hot-plug components
- 8.2 Non-hot-plug components
- 9 Appendix: server specification
- Index
106 Operating Manual TX150 S7
Non-hot-plug components CSS components
8.2.2 Replacing the system fan
V CAUTION!
Since the system fans are not redundant, defective system fans have to
be replaced immediately.
Figure 28: Removing the system fan
Ê Press on the green lock bar of the system fan in direction of the arrow (1)
and remove the system fan (2).
Ê Disconnect the system fan cable from the connector FAN1 SYS on the
system board (3).
Ê Connect the fan cable of the new system fan to the connector FAN1 SYS on
the system board.
Ê Insert the new system fan. The proper system fan position can best be
judged from outside at the back of the server. When doing so, make sure the
system fan lock bar engages properly.
1
/
0