Operation Manual
Table Of Contents
- Contents
- 1 Preface
- 2 Installation steps, overview
- 3 Important information
- 4 Hardware installation
- 5 Starting up and operation
- 5.1 Access to the drives (floorstand model)
- 5.2 Control elements and indicators
- 5.3 Switching the server on and off
- 5.4 Configuring the server
- 5.4.1 Configuring the onboard SATA controller
- 5.4.2 Configuring the SAS/SATA RAID controller
- 5.4.3 Configuring the server and installing the operating system with the ServerView Installation Manager
- 5.4.4 Configuring the server and installing the operating system without the ServerView Installation Manager
- 5.5 Cleaning the server
- 6 Property and data protection
- 7 Troubleshooting and tips
- 7.1 Power-on indicator remains unlit
- 7.2 Server switches itself off
- 7.3 Screen remains blank
- 7.4 Flickering stripes on monitor screen
- 7.5 No screen display or display drifts
- 7.6 No mouse pointer displayed on screen
- 7.7 Incorrect date and time
- 7.8 Drives reported as “dead” when starting system
- 7.9 Added drive reported as defective
- 7.10 Error message on screen
- 7.11 Expansion cards or onboard devices not recognized
- 7.12 Temperature warning
- 7.13 No effect of keyboard or mouse
- 7.14 Optical drive cannot read data
- 8 CSS components
- 8.1 Hot-plug components
- 8.2 Non-hot-plug components
- 9 Appendix: server specification
- Index
104 Operating Manual TX150 S7
Non-hot-plug components CSS components
8.2.1 Opening the server and identifying the defective
CSS component
8.2.1.1 Opening the server
V CAUTION!
The server can be seriously damaged if it is opened without authorization
or if repairs are attempted by untrained personnel.
It is essential to observe the safety instructions in chapter "Important
information" on page 27.
V CAUTION!
● Before removing or attaching covers, turn off the server, all peripheral
devices,and any other connected devices. Also unplug all power
cables from the outlet. Failure todo so can cause electric shock.
● The housing cover must be replaced as soon as possible for
purposes of cooling, to comply with EMC regulations (regulations
regarding electromagnetic compatibility) and to prevent fires. The
housing cover must not remain open for longer than 5 minutes.
V CAUTION (for rack model)!
● Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
● Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.