User Manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
173
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Multifeed
(page 195)
Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
None / Check Overlapping (Ultrasonic) /
Check Length / Check Overlapping and
Length
Length (When [Check Length] is specified;
select from 10/15/20 mm)
None
Length: 10 mm
Page Edge Filler (ADF)
Page Edge Filler (FB)(For fi-
7260/fi-7280)
(page 184)
Specify a width for the margin around the edge
of the scanned image to fill in white or black,
according to the background color.
This setting can also be configured in the
scanner driver. In that case, Page Edge Filler of
the scanner driver is used on the output image.
ADF:
Top / Left / Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1)
FB (For fi-7260/fi-7280):
Top / Bottom / Left / Right: 0 to 15 mm
(A: image, B: filled area, A+B: output)
Top/Bottom/Left/
Right: 0 mm
Dropout color
(page 186)
Select a color to be removed from the scanned
image (only available in black & white or
grayscale mode).
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Red / Green / Blue / None Green
Pre-Pick
(page 187)
Select [Yes] to prioritize the processing speed
and [No] for otherwise.
This setting can also be configured in the
scanner driver or the operator panel. Note that
priority is given to the scanner driver setting.
Yes / No Yes