User manual

Chapter 4 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
78
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Configuring the
Scan Settings
6: LCD Contrast Specify the contrast for the LCD on the operator
panel.
Weak Strong
■□□□□
■■□□□
■■■□□
■■■■□
■■■■■
■■■□□
7: Check LED Blink
Speed
Specify the flash interval for and LED
indicator if is flashing on the LCD.
0.5, 1.0, 1.5, 2.0, 2.5 (seconds) 2.0
8: LCD Scroll Speed Specify the speed in which the display is
horizontally scrolled.
The displayed item is scrolled horizontally when the
text does not fit in the LCD.
1: Fast
2: Normal
3: Slow
4: OFF
2: Normal
9: Doc Counting
Mode
You can count the number of scanned documents
in Doc Counting Mode.
--
10: iMFF Setting When there is a paper of the same size attached to
a designated location on the page, configure the
scanner to memorize the location of the attachment
and not detect multifeeds for that location.
Note that you need to specify [Check Overlapping
(Ultrasonic)] in either the scanner driver or the
multifeed detection setting in "Specifying a
Multifeed Detection Method [Multifeed]" (page 195)
beforehand.
By selecting [4: Clear pattern], you can clear the
overlapping patterns (length, location) that were
previously memorized in Auto mode.
This setting can also be configured from the
Software Operation Panel.
1: Manual mode
2: Auto mode 1
3: Auto mode 2
4: Clear pattern
1: Manual
mode
Item Description Parameter (*1)/Value Factory
Default (*2)
-: No settings/values