User manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
206
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Scanner Maintenance and Inspection Cycle
[Maintenance and Inspection Cycle]
Specify the period of time for regular maintenance and
inspection of the scanner by a service engineer.
When the specified period has passed after the last regular
maintenance and inspection date, flashes on the
LCD.
In this case, [maintenance] flashes on the second line in the
[Ready] screen.
Check the information and perform a regular maintenance and
inspection on the scanner by a service engineer.
For details about checking the information, refer to "Checking
the information" (page 71).
For regular maintenance and inspection on the scanner by a
service engineer, contact your FUJITSU scanner dealer or an
authorized FUJITSU scanner service provider.
1 Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2 From the listing on the left, select [Device Setting 2] 
[Maintenance and Inspection Cycle].
3 Select whether to enable or disable [Maintenance and
Inspection Cycle].
If you select [Enable], select the period of time for regular
maintenance and inspection of the scanner by a service engineer.