User manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
188
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Number of Paper Feeding Retries
Configure this setting to change the number of feeding retries
when a pick error occurs.
1 Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2 From the listing on the left, select [Device Setting 2] 
[Number of paper feeding retries].
3 Specify the number of paper feeding retries.
The value can range from 1 to 12 times.
Document Feed Speed [Pick Speed]
When you experience frequent multifeeds and paper jams, the
symptom may be improved by slowing down the speed in
which documents are picked (fed).
This setting is effective when you scan thin paper.
1 Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2 From the listing on the left, select [Device Setting 2] 
[Pick Speed].
HINT
This setting can also be configured in the operator panel.