User manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
176
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Manual-feed timeout
(page 201)
Select whether to disable or enable manual
feeding.
Disable / Enable Disable
Paper-out detection time: Specify the waiting
time to cancel manual feeding.
This setting can also be configured in the
operator panel.
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110
(seconds)
10 seconds
Power SW Control
(page 203)
Specify the method by which the scanner is
powered on/off.
Enable power switch / Disable power switch /
Enable USB power feeding
Enable power
switch
Paper Protection
(page 190)
Select a paper protection detection method.
This function can be set to reduce the risk of
having the documents damaged by detecting
anomalies upon feeding the documents and
stopping the scan when:
z The scanner detects a document that is
unusually warped when a feeding error
occurs.
z The scanner detects paper jam noise
z The scanner either detects a document that
is usually warped when a feeding error
occurs or detects paper jam noise
This setting can also be configured in the
scanner driver or the operator panel. When the
operation panel setting is prioritized, the
operator panel setting is prioritized over the
Software Operation Panel setting. Note that
even if the operation panel setting is prioritized,
the scanner driver setting has the highest
priority.
Disable/Feeding Accuracy/Feeding Noise/
Feeding Accuracy & Noise
Feeding
Accuracy
Paper Protection Sensitivity
(page 192)
Specify the sensitivity level to detect anomalies
upon feeding the documents when paper
protection is used.
This setting can also be configured in the
operator panel. When the operation panel
setting is prioritized, the operator panel setting
is prioritized over the Software Operation Panel
setting.
Detect: Feeding Accuracy/Feeding Noise
Low/Normal/High
Normal
Item Description Parameter/Value Factory Default